Principles for placing goods shelves.metal TV stand for 42 inch TV

　　1. The goods on the shelves should be placed according to the principle of low weight, high weight, and light weight, that is, heavy goods should be placed on the bottom layer and light goods on the top layer to avoid safety accidents caused by unstable heavy goods. However, it is usually allowed to place goods of the same weight as the top layer in the middle and lower layers.

　　2. When placing goods on shelves, if any deformation of the crossbeam is found, it should be removed and replaced with a new crossbeam in a timely manner to prevent quality issues with the crossbeam from causing the shelves to collapse.

　　3. When placing goods, consideration should be given to the time required to remove the goods, in order to avoid increasing time costs due to the impact on their removal and placement. When placing goods, the load-bearing capacity of the shelves should also be considered to avoid excessive load-bearing. This not only affects the service life of the shelves, but also leads to safety accidents, so it must be taken seriously.

　　Dongguan Shelf Factory tells everyone that warehouses should be partitioned according to different storage functions. The reasonable planning and layout of each functional area will have a significant impact on the efficiency, quality, cost, and profitability of warehouse operations. One-third of the total area used is for non storage functions. Unless restricted by conditions, logistics entrances and exits should be planned within an area.

Read recommendations:

cabinet shelf Factory

8 ft wire closet shelf Manufacturing

Material composition of cantilever shelves.18 x 30 chrome wire shelf