Rack factory attic type rack structure design detail

　　1, loading and unloading port: when designing the guardrail, it is necessary to consider the problem of loading and unloading port. The loading and unloading port adopts sliding door or pushing door, and the width is 1500-2000mm. Recommended fluent frame above the steel

　　2, shelf type: attic shelf.

　　3. Attic floor: the floor above the partition shelf and the fluent shelf, the location and area are shown in the drawings.

　　4, rated load: not less than 300 kg/square (fluent shelf above not less than 500 kg/square)

　　Note: The floor above the fluent frame is supported by the upright column of the fluent frame. The specifications of the column, main beam and secondary beam are determined by the manufacturer. See the drawing for the specific structure

　　1, protective guardrail: the use of not less than ￠33 connecting rod fixed on the column, the specific form can be formulated according to the company's situation, but at least the waist position to set up a horizontal guardrail.

　　2. Floor description: the upper edge of the floor is 2360mm from the ground height.

　　3. Type of goods: carton

　　4, stairs: a total of 3 stairs, the specific location of the drawings. The slope of the stairs should be less than 45. The height between the stairs is about 220, according to the total height, if necessary, the lower or upper distance can be increased to about 300, but it is not allowed to interval different heights in the middle position. The length of each stair board under each stair board protruding in the vertical direction must be at least greater than the length of more than two-thirds of the feet, that is, about 230.

　　5, back sealing net: the left side is easier to drop goods than the outside shelf, requiring the back sealing plate or back sealing net after the shelf.

Read recommendations:

MZG Steel Storage Shelving 4-Tier Wide, Black

4 tier wire shelving unit price

Principles and key points of storage shelf design